Capacity
All power take-offs are specifically designed for traveling hydraulic pumps to SAE J744C series ‘B’ specification with splined input shaft and either two-bolt or four-bolt fixing. The maximum power which can be transmitted can be 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off gives pump rotation exactly like the engine, where as the direct drive power take-off for the PRM500 and PRM750 gives opposite rotation. Power to the pump isn’t affected by the normal utilization of the gearbox for propulsion responsibilities. All ancillary power circuits powered by PRM power take-offs ought to be designed in accordance with the suggestions of the hydraulic gear manufacturer, and really should be properly safeguarded against overloading.
Cài đặt
PRM power take-off products fit on the trunk face of the main gearcase and are driven by the input shaft; consequently they may be operated all the time whilst the engine can be running, The energy take-off replaces the finish cover which is normally fitted and performs the functions of the end cover by sealing the gearbox against lack of oil and correctly positions the insight shaft back bearing. Power take-off products provide the link between the gearbox and the hydraulic pump.
Direct Drive Power Take-Off
Available on the PRM500 and PRM 750 the immediate drive power take-off is usually driven directly from the gearbox insight shaft; consequently it will operate all the time when the engine can be 
operating, and since there is absolutely no clutch for disengagement of the hydraulic pump, provision must be made in the auxiliary hydraulics circuits for pressure by-complete to the reservoir when capacity to the pump is not needed. A pair of 1:1 ratio gears, providing sufficient offset between your gearbox result shaft and the centreline of the power take-off to make sure there is enough clearance between the hydraulic pump and propeller shaft coupling.
Thông số kỹ thuật
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that suits a groove on input shaft of rotary mower
Contact us today to figure out more regarding hộp số pto.
