SMR Gearbox Installation
Satisfactory performance relies on proper set up. lubrication and maintenance. hence it’s important that the directions within the set up and maintenance leaflet. provided with each and every gearbox. are followed very carefully. some of the critical elements of belt and torque-arm installation are listed beneath.
one. Install pulley on gearbox input shaft as near towards the reducer possible, and mount reducer on driven shaft as shut to bearing as sensible. failure to try and do this will result in extra loads within the input shaft bearings and output bearings and could cause their premature failure.
2. Install motor and wedge belt drive with all the belt pull at roughly 90° towards the center line in between driven and input shafts. this can allow tensioning of your wedge belt drive using the torque arm which should really ideally be in stress. if output hub runs anti-clockwise. torque arm should be positioned the proper.
3. lnstall torque-arm fulcrum on the rigid help so that the torque-arm will probably be at approximately suitable angles to the center line through the driven shaft plus the torque arm case 
bolt. make sure there may be adequate consider up while in the turnbuckle for belt stress adjustment.
Retain near.
Bell drive might be situated in any convenient postion. when the torque arm would be to be utilised to tighten the belts, the drive must be at about tight angle on the line amongst the input and output shafts.
Bell drive may very well be situated to the ideal if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite course to that shown while in the illustration.
Torque arm and belt get up.
Torque arm may be mounted for the suitable if preferred.
