Basic
![](\"https:\/\/img.hzpt.com\/1207\/POWER%20UNITS%20FOR%20LIFT%20TABLE%202.jpg\")
\uc124\uba85This power unit is intended exclusively for that small lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become widely used within the marketplace of logistic units such as minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed by the solenoid valve using the speed managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Standard Description
This energy unit is intended solely for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the velocity controlled through the adjustable needle valve. When the lift rises to a higher positoin, however the electrical power supply is minimize, the decreasing motion is controlled through the guide override perform.
Energy UNITS FOR LIFT TABLE 3
Common Description
This energy unit is designed exclusively for the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the speed managed by a stress compensated flow manage valve.
Energy UNITS FOR LIFT TABLE 4
\uae30\ubcf8 \uc124\uba85
This electrical power unit is built exclusively for your massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the speed managed through the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is cut, the lowering motion is managed through the manual override perform.
Exclusive Notes
1.\tThis power unit is of S3 duty cycle, which can only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2.\tClean every one of the hydraulic components concerned prior to installation of the energy unit.
3.\tViscosity of the oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities.N46 hydraulic oil is suggested.
4.\tOil transforming is needed following the first a hundred operation hours,afterwards after every 3000 hrs.
five.\tThe energy unit shown is designed to be mounted vertically.<\/p>","protected":false},"excerpt":{"rendered":"